Page 1 of 1
Is it me or is the variation sticky missing? Q on 18d dozer
Posted: Tue Sep 09, 2014 7:59 pm
by Brad Pittiful
i couldve sworn there was a sticky for adding missing variations
well i was cataloging some models and have a 18d caterpillar bulldozer with SPW...no hole in base...blade brace...square rear brace...large exhaust pipe...small engine fittings and no infill
according to nicks guide this should have a hole in the base...mine does not
Re: Is it me or is the variation sticky missing? Q on 18d do
Posted: Wed Sep 10, 2014 3:17 am
by kwakers
Nice new variation Brad! I have a similar model with SPR, no base hole, with blade brace, but I believe mine may have the round edged ridge on the inside at the rear, unlike your squared one. I will have to verify that with the excellent pictures at Nick's site to make sure I am correct on that rear ridge. Stannard's illustrations were not as clear as Nick's actual pictures, so I was a bit confused when I coded the #9s and the #18s. kwakers
Re: Is it me or is the variation sticky missing? Q on 18d do
Posted: Wed Sep 10, 2014 5:45 am
by Brad Pittiful
cool Dick...be interesting to find out if yours is round or square
Re: Is it me or is the variation sticky missing? Q on 18d do
Posted: Wed Sep 10, 2014 5:30 pm
by mike
Interesting Dan.
I will examine my models once again.
Re: Is it me or is the variation sticky missing? Q on 18d do
Posted: Wed Sep 10, 2014 6:02 pm
by kay
I have one exactly like you - I listed it as a Stannard code 3a.
Kay
Re: Is it me or is the variation sticky missing? Q on 18d do
Posted: Thu Sep 11, 2014 12:20 am
by Brad Pittiful
mike wrote:Interesting Dan.
I will examine my models once again.
good luck Mike!
Re: Is it me or is the variation sticky missing? Q on 18d do
Posted: Thu Sep 11, 2014 12:21 am
by Brad Pittiful
kay wrote:I have one exactly like you - I listed it as a Stannard code 3a.
Kay
cool Kay looks like we have two for sure and depending on Dick and Mike we may have more!
Re: Is it me or is the variation sticky missing? Q on 18d do
Posted: Fri Sep 12, 2014 5:43 pm
by mike
Brad Pittiful wrote:kay wrote:I have one exactly like you - I listed it as a Stannard code 3a.
Kay
cool Kay looks like we have two for sure and depending on Dick and Mike we may have more!
Sorry, Brad.
I checked my model. See a code 1
But good luck in search of new code.
1 + 1 = 2 this is a new code.
Greetings Mike
