Is it me or is the variation sticky missing? Q on 18d dozer

[Brad Pittiful]

i couldve sworn there was a sticky for adding missing variations

well i was cataloging some models and have a 18d caterpillar bulldozer with SPW...no hole in base...blade brace...square rear brace...large exhaust pipe...small engine fittings and no infill

according to nicks guide this should have a hole in the base...mine does not

[kwakers]

Nice new variation Brad! I have a similar model with SPR, no base hole, with blade brace, but I believe mine may have the round edged ridge on the inside at the rear, unlike your squared one. I will have to verify that with the excellent pictures at Nick's site to make sure I am correct on that rear ridge. Stannard's illustrations were not as clear as Nick's actual pictures, so I was a bit confused when I coded the #9s and the #18s. kwakers

[Brad Pittiful]

cool Dick...be interesting to find out if yours is round or square

[mike]

Interesting Dan.
I will examine my models once again.

[kay]

I have one exactly like you - I listed it as a Stannard code 3a.

Kay

[Brad Pittiful]

Interesting Dan.
I will examine my models once again.

good luck Mike!

[Brad Pittiful]

I have one exactly like you - I listed it as a Stannard code 3a.

Kay

cool Kay looks like we have two for sure and depending on Dick and Mike we may have more!

[mike]

I have one exactly like you - I listed it as a Stannard code 3a.

Kay

cool Kay looks like we have two for sure and depending on Dick and Mike we may have more!

Sorry, Brad.
I checked my model. See a code 1

But good luck in search of new code.
1 + 1 = 2 this is a new code.

Greetings Mike