VBD2 is closed. Please go to https://vbd3.co.uk instead.

None of the NAMC’s “Catalog of all Series Matchbox Models” (first edition), the AIM “1-75 Series Regular Wheels” catalogue (second printing, 1983), Stannard nor Houghton has any variations not already listed by Nick, and U.K. Matchbox never covered the model.

As I have been checking my 63c models, I have discovered a small mistake by specifying the wheel dimension. There is no wheel variation with BPW ø12,5x48 as it is mentioned in the Nick´s list. It should be BPW ø12,5x45 (exactly ø12,35x45). There is one unlisted variation with thin BPW ø12,5x40. The wheels ø12,5x40 are approx. 3,45mm thick and the wheels ø12,5x45 are approx. 4,4mm thick.
Antonin

There is another unlisted variation with axle braces:
a) small braces
b) large braces

I've often thought some of the modifications, over the years, were nothing more than busy work or "job security."

I have a few of these crane trucks and each has No 37 on the topside of the cab glass - given that the model number is 63 does anyone know why there is a mismatch between the two ?

Thanks in anticipation

Sebastian

Sebastian10 wrote:I have a few of these crane trucks and each has No 37 on the topside of the cab glass - given that the model number is 63 does anyone know why there is a mismatch between the two ?

Thanks in anticipation

Sebastian

Greetings Sebastian
The cab of the 63c Dodge Crane Truck and the 37c Dodge Cattle Truck are basically the same cab and therefore share the same glazing insert. The Cattle Truck presumably was completed first, so the glazing insert got that number. (More knowledgeable members, please chime in if I have the sequence out of order. )
I Hope that helps.
Regards,
Kurt

Diecast wrote:There is another unlisted variation with axle braces:
a) small braces
b) large braces

would it be better to call the braces...short and long vs small and large

Kurt

Thanks for this prompt reply

Sebastian

MatchboxFreak wrote:

Sebastian10 wrote:I have a few of these crane trucks and each has No 37 on the topside of the cab glass - given that the model number is 63 does anyone know why there is a mismatch between the two ?

Thanks in anticipation

Sebastian

Greetings Sebastian
The cab of the 63c Dodge Crane Truck and the 37c Dodge Cattle Truck are basically the same cab and therefore share the same glazing insert. The Cattle Truck presumably was completed first, so the glazing insert got that number. (More knowledgeable members, please chime in if I have the sequence out of order. )
I Hope that helps.
Regards,
Kurt

That's pretty much the whole story.

Brad Pittiful wrote:

Diecast wrote:There is another unlisted variation with axle braces:
a) small braces
b) large braces

would it be better to call the braces...short and long vs small and large

I agree with Dan about the naming of those 'Braces' and assuming a Third brace does not exist, 'Short' and 'Long' seems a better description.

Ghosthunter.