Bracelet charms are more likely to have a small metal ring at the rear of the car for attatching to the main bracelet chain. You will have noticed it is on the roof of my ''FAB 1'' model. Tie-pins tend to have a spike cast to the bottom of the car which when passed through the material is hled in place with a metal clasp or clip.ritchie wrote:
Thanks, the smooth finish looks fabulous. So at the bottom was it supposed to have something attached to enable the function as a bracelet charm or a tie-pin?
If yours has no evidence of either of those fittings it is impossible to say what or why it was made. Two other slightly less plausible reasons for it's existance...
1, It may be from a board game similar to Monopoly.
2, It may be a from an Architecture's town planning set of vehicles, but these are usually made of resin, not plated.
Ghosthunter.
