Page 2 of 3
Re: What is this?
Posted: Sat Nov 29, 2014 11:41 am
by mike
johnboy wrote:I thought I'd put this in your thread Linus. There's a nice round hole which goes completely through the baseplate, it seems a bit extreme as a marker. Any ideas?
Interesting Johnboy.
I think a rivet hole in the wrong place.
Re: What is this?
Posted: Sat Nov 29, 2014 11:55 am
by johnboy
It could be Mike, it seemed a bit smaller than a rivet hole, perhaps it was a test shot or a misplacement. Were rivet holes pilot drilled first or drilled once?
Re: What is this?
Posted: Sat Nov 29, 2014 12:02 pm
by mike
I also think Johnboy.
In reviewing my models,
I have these different spacings found.
Perhaps an interesting millimeter work for Antonin.
Re: What is this?
Posted: Sat Nov 29, 2014 12:39 pm
by GHOSTHUNTER
I think your model Johnboy, is suffering from 'Mazacworm' a funny little Copper-Zinc eating fellar, that creeps up on your models when your not looking and burrows it's way in to the surface. Once he's in that's it, the model is a gonna. If left alone, that model will look like a Collendar in a few Weeks time.
Ghosty.
Re: What is this?
Posted: Sat Nov 29, 2014 12:43 pm
by johnboy
GHOSTHUNTER wrote:I think your model Johnboy, is suffering from 'Mazacworm' a funny little Copper-Zinc eating fellar, that creeps up on your models when your not looking and burrows it's way in to the surface. Once he's in that's it, the model is a gonna. If left alone, that model will look like a Collendar in a few Weeks time.
Ghosty.
Thanks Ghosty, I've got a team of scientists to inspect the hole, but no answers yet because they're still looking into it.
Re: What is this?
Posted: Sat Nov 29, 2014 12:54 pm
by GHOSTHUNTER
You have a 'PM' Johnboy.
Ghosty.
Re: What is this?
Posted: Sat Nov 29, 2014 1:11 pm
by johnboy
GHOSTHUNTER wrote:You have a 'PM' Johnboy.
Ghosty.
You too Ghosty.
I'm shocked, I turned my back for two minutes and this is the horrible sight that confronted me. I'm in a state of panic, I think it may be an epidemic. What do I do?
Re: What is this?
Posted: Sat Nov 29, 2014 1:17 pm
by johnboy
It's getting worse HELP!
Re: What is this?
Posted: Sat Nov 29, 2014 1:24 pm
by fixer
Could it have been fixed to some sort of gift ware like the #5 busses
Re: What is this?
Posted: Sat Nov 29, 2014 3:42 pm
by mike
johnboy wrote:It's getting worse HELP!
John Boy, that's the dangerous Moko worm.
Your entire collection is in danger.
Please make the whole collection over night in the freezer.
The next morning the collection in a large pot,
and about 100 degreesheat up.
After cooling, remove the worms, and seal the holes.
If it does not work.
There is still the hydrochloric acid treatment.
I wish you and your models all good.
