Page 2 of 2
Re: 73a RAF 10 ton Pressure Refuleller, unlisted variation
Posted: Wed Jan 29, 2014 7:40 pm
by mike
Diecast wrote:HI Mike
Yes, it is a variation with closed oblong hole. The variation with open hole is rarer.
Antonin
Thank you Antonin.
and, of the metal casting under the tank? is okay?
Re: 73a RAF 10 ton Pressure Refuleller, unlisted variation
Posted: Wed Jan 29, 2014 8:02 pm
by Diecast
It is OK. Standard gap, no infill.
Antonin
Re: 73a RAF 10 ton Pressure Refuleller, unlisted variation
Posted: Wed Jan 29, 2014 8:40 pm
by nearlymint
Hi Antonin,
I also have seen this hole before.
- 73a
- ref.jpg (145.68 KiB) Viewed 491 times
Bit I am still looking for the infill one.
Jason
Re: 73a RAF 10 ton Pressure Refuleller, unlisted variation
Posted: Wed Jan 29, 2014 9:16 pm
by Diecast
Hi Jason, do you have the open hole by code 2? I have the question to code 1. Does your brace small round or oblong cross-section?
Antonin
Re: 73a RAF 10 ton Pressure Refuleller, unlisted variation
Posted: Wed Jan 29, 2014 9:27 pm
by nearlymint
Diecast wrote:Hi Jason, do you have the open hole by code 2? I have the question to code 1. Does your brace small round or oblong cross-section?
Antonin
My open hole model is a code 1 with an oblong flat brace.
Jason
Re: 73a RAF 10 ton Pressure Refuleller, unlisted variation
Posted: Sat Feb 01, 2014 8:36 am
by Diecast
nearlymint wrote:Diecast wrote:
My open hole model is a code 1 with an oblong flat brace.
Jason
I have code 1 with closed hole. I have open/closed hole by code 2. It seems that former code 1 should be changed to code 1 and 2, and former code 2 should be changed to 3 and 4.
Antonin