
Can you tell what it is yet.
Re: Can you tell what it is yet.
oh and Paul Carr is not allowed to play as he would get it straight away.
Re: Can you tell what it is yet.
Looks like a shot-sleeve,that holds the molten metal used for the die casting, before it is pressed into the mould.
or perhaps the plunger for the shot-sleeve.
zBret
or perhaps the plunger for the shot-sleeve.
zBret
Re: Can you tell what it is yet.
Keep guessing guys, it helps to keep things straight ?
Re: Can you tell what it is yet.
I'll take one more guess...an alignment pin for the two halves of the diecast mould
zBret

zBret
Re: Can you tell what it is yet.
It looks like a compression roller. Don't know what it came off of, or if it's run in a pair.
It might be time to start my "Bucket List."
Re: Can you tell what it is yet.
From a sex toy shop in the Land of the Amazons?
Cam
Cam
If it wasn't for drugs, alcohol, and stupidity, I'd be out of work!
Re: Can you tell what it is yet.
Piston from injection moulding machine ????
-
- Posts: 200
- Joined: Sun Sep 15, 2013 5:53 pm
- Location: LHC, AZ USA.
Re: Can you tell what it is yet.
johnboy wrote:Maybe it's a tall hash tray from the boardroom?motorman wrote:Is it a tall Ash tray from the board room?
I going with johnboy on this one...I'm sure back in the 60ds there was a lot of that going on

Dave
So. Cal. USA.
So. Cal. USA.